One of the biggest challenges you can have when behind the wheel is looking out for blind spot. This could be difficult even with a pre-installed blind spot monitoring system.
What you should know is that all cars have blind spots, whether you like it or not. There is always an area on your retina with no receptor. When you admit that not all areas around your car are fully covered by a blind spot detector, it will help you in avoiding any form of accident accustomed to that. It is also important to know that there is no foolproof method as movement of your car can tell on the proper positioning of the mirrors. To save yourself from possible collision, follow these steps in checking for blind spots in your car, suggested by Naijauto.com!
1. How to check for blind spots before driving
Adjusting your seat
It is important you adjust your seat properly before you even think of starting the car engine. This will give you very much needed visibility of the road ahead.
Adjusting your side view mirrors
The best angle to set your side view mirror to is 15 degree. This will prevent any occurrence of seeing any reflection of your car obstructing the side mirror. When people fall victims of road accidents, it is might be due to ineffective adjustment of the side mirrors. Another thing you should take into consideration is that you must lean your head to the left side so that it is in the same line with the edge of the window.
You don't need to pull your head all out. Adjust your rear mirror properly!
Make sure you adjust the side mirror in the driver’s side in outward position until you have achieved the point where your car side is no longer visible.
Adjusting the passenger’s side mirror
This can be very tricky too if you do not know how to properly adjust the mirror at the passenger side. Relax, it is quite simple. What you need to do is positioning your head at the center point inside your car. You can use overhead dome light to set the vantage point. At this point, just set the side mirror of the passenger side to stop seeing the side of the car through the passenger’s side mirror.
>>> Watch out for the threats inside your car as well! 4 types of distracting songs you should not listen to when driving
2. How to check for blind spots while driving
Always turn your head appropriately
Each time you make a turn, reverse or change lane, it is required that you turn your head to the direction you are aiming at. This is a smart move to prevent any possible hazard or road obstacles. This doesn’t mean you just turn your head in 360 degree while driving. Your shoulder should provide a guide to what extent you can turn your head.
Practice turning your head to where you are aiming for is key of smart driving
Always consider other motorist’s blind spots
Observing and minding your own blind spot is good but not enough for safe driving. You need to put other motorists plying the road into consideration. This means you need to take precaution as not to fall within their blind spots. It is highly recommended for safety purpose, you should allow the car to pass you or move along.
How To Check Your Blind Spot - Basic Driving Lesson
A smart driver understands the need to always adhere not to only one method of checking blind spots, but all possible available hints. This will give you the chance to have a proper view of various forms of activities happening around your car on the road. Despite the technological advancement in modern blind spot detection system and even the introduction of convex mirrors, you cannot override the importance of shoulder inspection and perfectly aligned side view mirrors on the driver and passenger sides.